Construction electric

A construction site is vulnerable to hazards caused by electricity. It is therefore extremely important that those working in the construction sector a lot of attention to prevent such disasters. Regulation 64 of the Regulations for Construction Safety was designed for this purpose. The following are the general requirements for the safety of this regulation.

1. If you do not plan to use a generator, ensure that the voltage is raised before construction starts. Never rely on a power supply from nearby buildings, as this creates many more problems than benefits.

2nd A main switchboard must be in place. This main switchboard must be well protected and easily accessible. In addition, this telephone is placed as close as possible to street level and shall be constructed of high strength materials.

3rd Distribution must be easily accessible. When construction takes place on several levels structure, each level has a distribution for easy access. Make it a habit of not flexible cords are stretched at all levels, if necessary, while working in the elevator shafts, stair wells and other work carried out simultaneously at several levels.

4th For power supply from run horizontally over the side, should the interval of 3 meters and a height of 2 meters.

5th Used for the power cord from the vertical, they must be supported every 6 feet and has a special support for the upper section.

6th Contact lines, which are used as air ducts, must be a double insulation is used. It is recommended that you add these antenna on ways to create circuits for vehicles. If this is unavoidable, but at least the antenna conductor clearance must be applied by 4 meters, 5 meters must be respected, and the wagon is placed at a distance of approximately 3.9 meters and 6 meters on both sides of the overhead lines.

7th With safety switches for portable cabins, welding and lighting is a must.

8. Flexible cables are not the vagina in the color green and shall be used in areas where they are under some form of injury. They should also be supported from the ground, where more than 10 feet from the unit they are connected and in driveways.

9th Inspection and testing must be done on any electrical equipment to be used in manufacturing. This is a very strict procedure which is likely to be studied. Also just when construction is about to use an electric equipment, these workers have a visual inspection of electrical equipment as an additional safeguard against distaste for injuries caused by electric shock.

These are the general requirements to follow closely the construction work. The study of these is recommended to ensure that these would be correct. Make sure it has taken all measures to avoid electrical hazards, is another step towards the construction site in a safe place for workers. For this reason, stay with rules for safety in construction is a must.